ETS6: configuring a heterogeneous installation, using TP & IoT devices

ETS6: Configuring a heterogeneous installation, using TP & IoT devices.

In the video below, a setup is used that contains TP devices and IoT devices. To be more exact, on each side a button and an actuator are configured.

The configuration contains that the actuators sends feedback to the buttons.

The network/KNX topology contains an TP section and an IoT section as follows:

This setup is then configured by means of ETS 6, showing the downloading and interoperability of the TP and IoT devices in the following video:

First Name

Last Name

Email Address

Country